Skip to content

Cutout Brake

Introduction

When operating locally, a motor cutout can be enabled to prevent the motor from engaging. This page provides an overview of the available inputs and instructions for configuring the corresponding parameters.

Wiring

A single-throw switch is typically used as the input source and can be connected to Cruise/Digital Input 1, PFS/Digital Input 2, Brake 1, or Brake 2.

When connecting to a digital input, note that these inputs are internally pulled up, so the switch should be wired between GND and the selected digital input.

If connecting to an analog brake input, ensure that the input is configured with a pull-up resistor.

Configuration

  1. Select the Cutoff brake sensor source (address 248)

  2. Enable the brake and verify ebike flags bit 1 Cutout is active